4 FUNCTIONS
4.2 Built-In Program Selection Function
53
4
Details of the program 3 for FX5-SF-MU4T5s
The following explains the program when the FUNCTION rotary switch is set to '3'.
For details on the connectable devices and ladder symbols in the program, refer to the following:
Page 48 Connectable devices and ladder symbols
In the program 3.1, link a sensor and logic path A or B as follows.
In the program 3.2, link a sensor and logic path A or B as follows.
Input for logic path A Assignment Input for logic path B Assignment
Single-channel N/C contact + to I0
+ to I1
Two muting sensors, two single-channel N/C
contacts or dual-channel non-isolated
semiconductor
+ to I2
+ to I3
Dual-channel N/C contact, three-wire + to I0
+ to I1
Dual-channel non-isolated semiconductor + to I0
+ to I1
Input for logic path A Assignment Input for logic path B Assignment
ESPE (sensors with semiconductor output) T1 to I1
(bridge T0
and I0)
Two muting sensors, two single-channel N/C
contacts or dual-channel non-isolated
semiconductor
+ to I2
+ to I3
Inductive switch with semiconductor output T0 to I0
(bridge
between T1
and I1)
To Next Page
Loading...
