4 FUNCTIONS
4.3 Off Delay Delay Setting Function
69
4
■Applying a setting
The program does not run only by selecting a built-in program using the rotary switch(es).
To run the selected built-in program, settings must be applied.
For the procedure for applying the settings, refer to the following:
Page 112 Applying a setting
Rearranging the wiring of X0, X1, and X2 after the settings have been applied will cause an error.
■Setting a control function
Depending on the wiring status of X0, X1, and X2, set an appropriate control function (restart interlock, external device
monitoring (EDM), or retriggering of the delayed OSSDs).
■Inspection of the connected device
Before changing the program, check if the connected devices operate properly.
For the inspection, refer to the following:
Page 114 COMMISSIONING
To Next Page
Loading...
