6 WIRING
6.1 Spring Clamp Terminal Block
91
6
Wiring of an electric wire
■When using a ferrule with insulation sleeve
Insert a wire to which a ferrule with insulation sleeve is cramped into the wire insertion opening.
■When using a single wire or strand wire
Using a flathead screwdriver, push the open/close button on the terminal block. While pushing the open/close button, insert
the wire securely until it reaches the end. After the wire is fully inserted to the end, release the open/close button.
<Reference>
After wiring, pull the wire slightly to check that the wire is securely clamped.
Disconnection of a wire
Using a flathead screwdriver, push the open/close button of the wire to be disconnected. While pushing the open/close button,
pull out the wire.
(1) Open/close button
(2) Wire insertion opening
(3) Wire
(4) Flathead screwdriver
Manufacturer Model
PHOENIX CONTACT GmbH & Co. KG SZS 0.4 × 2.5 VDE
To Next Page
Loading...
