SICK MPS-G

Q2
PWR
Q1
Q2
PWR
Q1
Q2
PWR
Q1
Q2
PWR
Q1
f f
fi
Q2
PWR
Q1
s
s s
f f
fi fi
si
s
s
x
1x
3 - 5 sec
(very long)
Delete
Qint
Action not preformed if button is released before
request time start
Reset Menu
Action preformed if button is
released within request time
Action not preformed if button is
released after request time end
0 sec 1 sec 1.2 sec 3 sec 5 sec time
LED behaviour
Off
On
Slow blink
Inverted slow blink
Fast blink
Inverted fast blink
Tallymark blink
* Qint = switch point
Qint
successfully deleted
Figure 19: Dynamic Teach-in teach-in procedure
Flashing tally sheet:
1mm = 1x brief flash
2mm = 2x brief flashes
3mm = 3 x brief flashes
4mm = 4 x brief flashes
5mm = 1 x long flash
8.3.2 Manual teach-in
Manual Teach-in is used to manually teach in up to three switching points within the measuring range using the
teach-in button. The three switching points are taught-in separately.
NOTE
After Manual Teach-in is run, the width of the switching point (see "Switching behavior after Manual Teach of up to 3
switching points", page 11) can be set.
8 OPERATION
32
O P E R A T I N G I N S T R U C T I O N S | MPS-G with 2/3 switching points and IO-Link (up to 8 switching points) 8028195/2022-11-30 | SICK
Subject to change without notice