Operating Instructions
NAV350
Electrical installation
8013889/ZML0/2017-06-09
© SICK AG · Germany · All rights reserved · Subject to change without notice 45
Chapter 5
5 Electrical installation
Only authorised personnel are allowed to perform the electrical installation work.
Do not open the housing.
Observe the current safety regulations when working on electrical systems.
Switch the entire machine/system offline!
The machine/system could inadvertently start up while you are connecting the device.
Ensure that the entire machine/system is disconnected during the electrical installa-
tion.
5.1 Overview of the installation steps
1. Wire switching outputs (application-dependent).
2. Temporarily connect PC (configuration).
3. Wire data interface for operation.
4. Connect supply voltage to the NAV350.
5.2 Connections of the NAV350
5.2.1 Connections of the NAV350
Fig. 26: Connections of the NAV350
The NAV350 has three round multi-pin M12 plug connectors.
“RS232” connection
M12×8, plug
“Power” connection
M12×5, plug
“Ethernet” connection
M12×4, socket
To Next Page
Loading...
