SICK NAV350

Electrical installation
48 © SICK AG · Germany · All rights reserved · Subject to change without notice
8013889/ZML0/2017-06-
09
Operating Instructions
NAV350 Laser positioning sensor
Chapter 5
5.4.2 Connecting supply voltage
Pre-assembled cables with flying leads are available for the supply to the NAV350.
Fig. 27: Connection of the voltage supply
5.4.3 Connection to the Ethernet interface
Pre-assembled cables are available to configure the NAV350 via the Ethernet interface.
Fig. 28: Ethernet connection
5.4.4 Connection at the RS-232 interface
A screened cable is required for the wiring of the RS232 interface.
 Pay attention to max. cable length as per section 5.3.3 “General conditions for the data
interface” on page 47.
Fig. 29: Wiring the RS232 interface
SICK AG | Waldkirch | Germany | www.sick.com
M12×5
Black = OUT1
Brown = V
s
Part no. 6043440, 5 m
Socket
Grey = GND
White = V
s
Blue = GND
DC 24 V
M12×4
RJ45
8 pin
Plug
Part no. 6034415, 5 m
Part no. 6030928, 10 m
Part no. 6036158, 20 m
Plug
PC