1. Affix the illumination unit to the device housing.
2. Manually adjust the focus and aperture of the lens and check these using the
SOPAS ET configuration software.
3. Attach the protective optics cover and screw it tight.
4. Attach the warning label to the protective optics cover near the light outlet so that
it is clearly visible.
5. If the device itself is, for example, integrated into a machine in such a way that the
attached warning label is obscured, attach further clearly visible labels to the
machine close to where the light is emitted.
SAFETY INFORMATION 2
8018071/16XD/2020-05-06 | SICK O P E R A T I N G I N S T R U C T I O N S | Lector63x Flex C-mount and S-mount
13
Subject to change without notice
To Next Page
Loading...
Need help?
General
