EasyManuals Logo

Siemens 1PL618 Series User Manual

Siemens 1PL618 Series
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
Transport, assembly, and connection
3.1 Transport, storage, and maintenance
A5E00215731A AD
Siemens AG Operating Instructions 2.02 1PL618
23
Offers protection against extreme weather conditions
The air in the room must not contain any harmful gases.
Protect the machine from shocks and humidity.
[ID 1079.01xx]
3.1.3 Preservation
Preservation
If you are storing a machine for more than six months, you must check its condition every six
months.
Check the machine for damage.
Carry out any necessary maintenance work.
Document all preservation measures taken so that they can be reversed before the
machines are put back into service.
Provide a constant source of low heat to the machine windings, along with forced air
ventilation.
CAUTION
Bearing damage caused by vibrations
If storage conditions are inappropriate there is a risk of bearing seizure damage. This
can result in material damage, such as damage to bearings due to vibration.
On machines that have been supplied with a rotor locking device, secure the rotor as
per the notes on transportation. Protect the machine against strong radial vibrations,
since the rotor locking device might not absorb these completely.
Condensation water
Condensation water can collect in the machine as a result of sharp fluctuations in ambient
temperature, exposure to direct sunlight, high levels of humidity in the storage location or
intermittent operation/variations in load during operation.
CAUTION
Damage caused by condensation water
If the stator winding gets damp, its insulation resistance decreases. This results in voltage
flashovers, which can destroy the winding. Condensation can also cause rusting inside the
machine.
Ensure that condensation water is drained off.
In the end shields at the drive end and non-drive end, water drain holes are situated in the
foot area and opposite the regreasing devices. They are sealed with small plastic plugs or
screw plugs. Depending on the type of installation, the water drain holes are located at the
bottom.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens 1PL618 Series and is the answer not in the manual?

Siemens 1PL618 Series Specifications

General IconGeneral
BrandSiemens
Model1PL618 Series
CategoryController
LanguageEnglish

Related product manuals