Siemens et 200sp - Configuring

Configuring/address space
4.6 PWM with DC motor motor
Technology Module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 05/2019, A5E35061186-AB
113
4.6.2 Configuring
Introduction
You configure the technology module and assign its parameters with the configuration
software.
The user program controls and monitors the functions of the technology module via the
control interface and feedback interface.
System environment
The technology module can be used in the following system environments:
Possible use
Components needed
Configuration software
In the user program
Centralized operation
with a CPU 151xSP
• ET 200SP automation sys-
tem
• TM Pulse 2x24V
STEP 7 (TIA Portal):
Device configuration and param-
eter setting with hardware con-
figuration
Direct access to control
interface and feedback
interface in the I/O data
Distributed operation
with an S7-1500 CPU
• S7-1500 automation system
• ET 200SP distributed I/O
system
• TM Pulse 2x24V
STEP 7 (TIA Portal):
Device configuration and param-
eter setting with hardware con-
figuration
Distributed operation
with an S7-300/400 CPU
• S7-300/400 automation
system
• ET 200SP distributed I/O
system
• TM Pulse 2x24V
STEP 7 (TIA Portal):
Device configuration and param-
eter setting with hardware con-
figuration
STEP 7:
Device configuration and param-
eter setting with HSP
Distributed operation on
the PROFINET IO in a
third-party system
• Third-party automation
system
• ET 200SP distributed I/O
system
• TM Pulse 2x24V
Third-party configuration soft-
ware:
Device configuration and param-
eter setting with GSD file
Distributed operation on
the PROFIBUS DP in a
third-party system
• Third-party automation
system
• ET 200SP distributed I/O
system
• TM Pulse 2x24V
Third-party configuration soft-
ware:
GSD file; device configuration
and parameter setting using data
record 128