Siemens et 200sp - Operating Mode

Configuring/address space
4.9 Explanation of parameters
Technology Module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 05/2019, A5E35061186-AB
129
4.9.2 Operating mode
Operating mode
You use this parameter to specify the function for which the channel of the technology
module is used. This defines the setting options under "Parameters".
Operating mode
Meaning
Mode-dependent parameters
Pulse output The channel outputs a single pulse. You specify the
pulse duration in the control interface.
• High-speed output (0.1 A)
• Function DI
• Input delay
• On delay
Pulse width modulation
PWM
(default)
The channel outputs a pulse width modulated signal.
You specify the duty cycle and/or the current setpoint in
the control interface.
• High-speed output (0.1 A)
• Function DI
1
• Input delay
• Output format
• Minimum pulse duration
• Period duration
• Actual period duration
• On delay
1
• Dithering
• Incline of dithering ramp up
• Incline of dithering ramp down
• Dithering amplitude
• Dithering period duration
• Current control
• Enable proportional action
• Enable integral action
• Enable derivative action
• Reference value current
• Dead band width
• Manipulated value high limit
• Manipulated value low limit
• Proportional gain
• Integration time
• Derivative action time
• Delay time of derivative action