Siemens et 200sp - Address Space; Control Interface and Feedback Interface; Assignment of the Control Interface

Configuring/address space
4.4 On/Off delay mode
Technology Module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 05/2019, A5E35061186-AB
89
4.4.5 Address space
Address space of the technology module
Table 4- 12 Size of input and output addresses
Inputs
Outputs
Size per technology channel
8 bytes
12 bytes
Size in one-channel operation
8 bytes
12 bytes
Size in two-channel operation
16 bytes
24 bytes
4.4.6 Control interface and feedback interface
Note
A
library of PLC data types (LPD) for STEP 7 (TIA Portal) and SIMATIC S7-1200 / S7-1500
is available for download on the Internet
(
https://support.industry.siemens.com/cs/ww/en/view/109482396).
4.4.6.1 Assignment of the control interface
The user program uses the control interface to influence the behavior of the technology
module.
Control interface per channel
The following table shows the control interface assignment:
Byte
offset
relative
to start
address
Channel
0/1
↓ ↓
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
0
…
3
12
…
15
OUTPUT_VALUE
UDINT: On delay
4
…
7
16
…
19
SLOT
UDINT: Load value
8 20 Reserved MODE_
SLOT
LD_SLOT