Siemens et 200sp - Reaction to CPU STOP

Configuring/address space
4.2 Pulse width modulation PWM mode
Technology Module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 05/2019, A5E35061186-AB
51
4.2.3 Reaction to CPU STOP
You set the response of the channel to a CPU STOP in the parameters of the device
configuration.
Table 4- 4 Response of channel to CPU STOP
Option
Meaning
Output substitute
value
The channel outputs the configured substitute values at the digital outputs until
the next STOP-RUN transition of the CPU. You can configure the substitute val-
ue 1 for only one of the two digital outputs.
An active output sequence is stopped and the STS_ENABLE feedback bit is
reset.
The technology module is set to its startup state after a STOP-RUN transition.
Before you can start a new pulse output, you must reset the SW_ENABLE control
bit.
Continue opera-
tion
The channel continues to operate.
The digital outputs continue to switch according to the parameter assignment. An
active output sequence will thus be continued. If you have configured the hard-
ware enable, you can also start additional output sequences using DIn.0.
The configuration of the technology module is not reset after a STOP-RUN transi-
tion.