Configuring/address space
4.4 On/Off delay mode
Technology Module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 05/2019, A5E35061186-AB
79
4.4 On/Off delay mode
4.4.1 Function
4.4.1.1 Introduction
In this operating mode, the respective channel of the technology module outputs pulses with
a specified switching delay relative to digital input DIn.0. You specify the On delay via the
control interface.
4.4.1.2 Output sequence
Starting the output sequence
In order to output the output sequence at the digital output DQn.A, the TM_CTRL_DQ control
bit (Page 126) must be set. To start the output sequence using the software enable, you set
the SW_ENABLE control bit (Page 89). The STS_SW_ENABLE feedback bit indicates that
the software enable in the technology module is active.
To Next Page
Loading...
