Siemens et 200sp - Page 14

Product overview
2.1 Properties
Technology Module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 05/2019, A5E35061186-AB
13
Properties
The TM Pulse 2x24V technology module has the following technical properties:
● 2 channels with up to 2 A output current per channel
● Parallel connection of channels: Enables one logical channel with up to 4 A output current
(one-channel operation)
● High-speed output: Choice of high output frequency up to 100 kHz with output current of
0.1 A or higher current of 2 A / 4 A with frequency up to 10 kHz
● Interfaces (per channel):
– 24 V sensor supply, short-circuit proof
– Digital input signal DI0
– Bipolar digital output signal DQA / DQB for DC motor
● Channel-by-channel monitoring for short-circuit and incorrect supply voltage
● Configurable input filters for suppression of interference at digital inputs
● Use of SW or HW enable to start the output sequence
Supported system functions
● Isochronous mode
● Firmware update
● I&M identification data
● Parameter reassignment in RUN
Accessories
A BaseUnit of type B1 is needed for operation of the technology module. You will find an
overview of the BaseUnits you can use with the technology module in Product information on
the documentation of the ET 200SP distributed I/O system
(http://support.automation.siemens.com/WW/view/en/73021864).
You can find additional information on accessories in the ET 200SP Distributed I/O System
system manual (http://support.automation.siemens.com/WW/view/en/58649293).