Siemens et 200sp - Page 152

Technical specifications
Technology Module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 05/2019, A5E35061186-AB
151
Article number
6ES7138-6DB00-0BB1
Switching capacity of the outputs
• with resistive load, max.
2 A
• on lamp load, max.
10 W; 1 W with High Speed output
Load resistance range
• lower limit
12 Ω; 240 ohm with High Speed output
• upper limit
12 kΩ
Output voltage
• Type of output voltage
DC
• for signal "0", max.
1 V
• for signal "1", min.
23.2 V; L+ (-0.8 V)
Output current
• for signal "1" rated value
2 A; 0.1 A with High Speed output, observe derat-
ing
Output delay with resistive load
• "0" to "1", typ.
0 µs; With High Speed output, 4.5 µs with Stand-
ard output
• "0" to "1", max.
0.8 µs; With High Speed output, 9 µs with Stand-
ard output
• "1" to "0", typ.
0 µs; With High Speed output, 4.5 µs with Stand-
ard output
• "1" to "0", max.
0.8 µs; With High Speed output, 9 µs with Stand-
ard output
Parallel switching of two outputs
• for uprating
Yes
Switching frequency
• with resistive load, max.
100 kHz; With High Speed output, 10 kHz with
standard output
• with inductive load, max.
100 kHz; With High Speed output, 10 kHz with
standard output
• on lamp load, max.
10 Hz
Total current of the outputs
• Current per channel, max.
2 A
• Current per group, max.
4 A
• Current per module, max.
4 A
Isochronous mode
Isochronous operation (application synchro-
nized up to terminal)
Yes
Bus cycle time (TDP), min. 250 µs; with 1 channel configuration, 375 µs with
2 channel configuration
Jitter, max.
1 µs; typically ±