1
11 |
Building Technologies
1.3 Revision history
The reference document's version applies to all languages into which the reference
document is translated.
The first edition of a language version or a country variant may, for example, be
version 'd' instead of 'a' if the reference document is already this version.
The table below shows this document's revision history:
Version Edition date Brief description
i 2015-12-15 Edition for IP6
New:
Polling the IP address of the 'Station'
Person Machine Interface with FBP [AU]
ALARM procedure PMI with FBP [AU]
Glossary entries in the text marked with '↑'
Damper control
Cyber security disclaimer
Revised:
Chapter 'Deactivating / activating alarm devices' adapted for PMI with FBP [AU],
referenced documents updated. Information added in chapter 'Cerberus-Remote
operation modes' for configuration of the permanent operation mode. Information
added to chapter 'Change language' on the preferred language and on retaining
the language after restarting. Safety and warning notices updated in chapter
'Switching off/on' and subchapters. Information added to chapter 'PIN
administration' on PIN configuration in Engineering Tool. Information added to
chapters 'Carrying out an installation test' and 'Installation test' on manual call
point zones and flashing behavior of the internal alarm indicator. Information
added to chapters 'Testing detectors' and 'Detector test' on the validity of the
detector test for all detector zone types. 'Information' and 'Maintenance' command
groups updated. # symbol added in chapter Event status identification [➙ 169]
h 2014-02-10 Chapters 'Commands with required access levels' and 'LEDs' updated
To Next Page
Loading...
Need help?
General
