Siemens FC7xx User Manual

System functions
Note on the configuration of the local fire detection installation
6
111 |
184
Building Technologies
A6V10211076_i_en_
--
Fire Safety
2015
-
12
-
15
6 System functions
See also
1 Event categories [➙ 168]
6.1 Note on the configuration of the local fire detection
installation
Each fire detection system is individually configured. The configuration has an
impact on the operation. You can see the configuration of your fire detection
installation in the following table.
Parameters Configuration
Operation level access O via password
O via key switch
Remote transmission of 'ALARMS' O yes
O no
Alarm sequence taking into account the staff present on site O yes
O no
Switching from 'Manned operation' to 'Unmanned operation' O automatic
O manual
Automatic switching time from 'Manned operation' to 'Unmanned
operation'
O indicated
O not indicated
Automatic switching time from 'Manned operation' to 'Unmanned
operation'
O not activated
Delay t1 ____ minutes
Delay t2 ____ minutes
Switchover
Summer time / Winter time
O automatic
O manual
Remote transmission of 'Faults' O yes
O no
Function Evacuate O activated
O not activated
Access to acknowledgement O always possible
O via password / key switch
'Faults' must be reset O yes
O no
'Faults' are generally immediately transmitted to the receiving centre O yes
O no
Manual call points in mixed detector zones always trigger an
'ALARM', even when the detector zone is switched off
O yes
O no
Maximum operation time without mains supply ____ hours
Building plan handed over on _________
by _________

Siemens FC7xx Specifications

General

Brand	Siemens
Model	FC7xx
Category	Control Panel
Language	English