Procedure in case of Fault
5
44 | 184
5.3 Procedure in case of Fault
Step Action
1 Press <Silence buzzer> on the ↑ Person Machine Interface
2 Read message/fault location on the display
3 Go to the fault location
4 Eliminate the cause of the fault
' and how they are eliminated can be found in the chapter
'Faults / Troubleshooting'. If you cannot eliminate 'Fault', please contact your
service provider.
'Fault' and 'Intervention Concept' (IC)
On consideration of 'Intervention Concept', events of the 'Fault' category can be
assigned their own sequence. This sequence may be configured differently and
depends on the ↑ 'Manned operation' / ↑ 'Unmanned operation' operation mode.
An exemplary process following 'Fault', taking into account 'Intervention Concept',
is graphically shown in chapter 'Intervention Concept (IC) and is outlined below:
'Fault' has occurred
● The remote transmission for 'Faults' is activated in 'Unmanned operation'
operation mode.
● The remote transmission for 'Manned operation' is activated in 'Faults'
operation mode unless 'Fault' is acknowledged within the delay t1.
Acknowledging 'Fault'
1. Press <Acknowledge> before the expiry of t1.
2. Read the 'Fault'location on the display.
3. Go to the 'Fault' location.
4. Rectify 'Fault'.
See also
1 Intervention concept (IC) [➙ 163]
1 Faults / Troubleshooting [➙ 174]
To Next Page
Loading...
Need help?
General
