hwc_vnsintro.fm
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
117
Virtual Network Services
VNS global settings
3. To define a RADIUS server available on the network, do the following:
● In the Server Name box, type a name.
● In the Server Address box, type the IP address.
● In the Shared Secret box, type the password that is required in both directions. This
password is used to validate the connection between controller and the RADIUS
server.
4. In order to proofread your password before saving the configuration, click Unmask. The
password is displayed. To mask the password, click Mask.
This precautionary step is highly recommended in order to avoid an error, later, when the
HiPath Wireless Controller attempts to communicate with the RADIUS server.
5. To add the server to the list, click Add.
6. To remove a server, select the server in the list and click Remove selected server.
7. To save your changes, click Save.
To Next Page
Loading...
