Siemens HiPath AP2620 - Page 249

hwc_ongoing.fm
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
249
Performing system maintenance
Performing system maintenance tasks
11. To apply your changes, click on the Apply button.
Table 18shows Syslog and Controller, Access Points and Convergence Software event log
mapping.
To force an immediate system shutdown:
1. From the main menu, click Wireless Controller Configuration. The Wireless Controller
Configuration screen appears.
2. From the left pane, click System Maintenance. The System Maintenance screen
appears.
3. To shut down the system, including associated Wireless APs, select the appropriate shut
down option:
● Halt system: reboot
● Halt system: reset database to factory default and reboot
● Halt system: reset to factory default and reboot
● Halt system,:shutdown power
4. Click Apply Now. The system is immediately halted.
>
The syslog daemon must be running on both the HiPath Wireless Controller and on
the remote syslog server before the logs can be synchronized. If you change the log
level on the HiPath Wireless Controller, you must also modify the appropriate setting
in the syslog configuration on remote syslog server.
Syslog Event Controller, Access Points and
Convergence Software Event
LOG_CRIT Critical
LOG_ERR Major
LOG_WARNING Minor
LOG_INFO Information
LOG_DEBUG Trace
Table 18 Syslog and Controller, Access Points and Convergence Software event log mapping