Siemens HT 8 - Default Chapter; Table of Contents

Table of contents
1 General information and networking.............................................................................................................7
1.1 Fundamental safety instructions..............................................................................................7
1.1.1 General safety instructions.......................................................................................................7
1.1.2 Handling electrostatic sensitive devices (ESD)......................................................................10
1.1.3 Industrial security...................................................................................................................10
1.1.4 Residual risks of power drive systems...................................................................................11
1.2 Application planning...............................................................................................................14
1.2.1 Secondary electrical conditions..............................................................................................14
1.2.1.1 Power supply..........................................................................................................................14
1.2.1.2 Grounding concept.................................................................................................................15
1.2.1.3 EMC compatibility..................................................................................................................15
1.2.2 Ambient climatic and mechanical conditions..........................................................................17
1.2.2.1 Transport and storage conditions...........................................................................................17
1.2.2.2 Operating conditions..............................................................................................................19
1.2.2.3 Cooling...................................................................................................................................20
1.2.3 Standards and approvals.......................................................................................................23
1.2.4 Recycling and disposal..........................................................................................................24
1.3 Connecting.............................................................................................................................25
1.3.1 Pin assignment of the interfaces............................................................................................25
1.3.2 Handling membrane connectors............................................................................................38
1.4 Networking.............................................................................................................................39
1.4.1 System settings......................................................................................................................39
1.4.1.1 Settings for SINUMERIK solution line....................................................................................39
1.4.1.2 System boot with system network..........................................................................................41
1.4.1.3 Thin Client Unit (TCU)............................................................................................................42
1.4.1.4 Factory default settings..........................................................................................................43
1.4.2 Commissioning TCU..............................................................................................................45
1.4.2.1 Using the TCU's main menu..................................................................................................45
1.4.2.2 Using additional TCU menus.................................................................................................47
1.4.2.3 How to register a TCU on the system network.......................................................................57
1.4.2.4 How to calibrate a touch panel...............................................................................................61
1.4.2.5 Connecting-up the SIMATIC Thin Client Touch Panel...........................................................63
1.4.2.6 This is how you configure the SIMATIC Thin Client Touch Panel..........................................64
1.4.2.7 Settings in the "config.ini" file.................................................................................................66
1.4.2.8 Settings in the "TCU.ini" file...................................................................................................68
1.4.2.9 Displacement mechanism for TCUs.......................................................................................74
1.4.2.10 Disable switchover between TCU via PLC.............................................................................76
1.4.2.11 Example: How to select the behavior of the TCUs during boot up.........................................78
1.4.3 Network configuration............................................................................................................79
1.4.3.1 Permissible network topologies..............................................................................................79
1.4.3.2 Networks without connection to the company network..........................................................80
1.4.3.3 Networks with NCU connection to the company network......................................................82
1.4.3.4 Example: Configuring a VNC connection to a PC..................................................................85
1.4.3.5 Application example...............................................................................................................87
Handheld Terminal HT 8
Manual, 07/2015, A5E36371621B-AB 3