If no HT 8 is connected, observe the following:
WARNING
Danger of death resulting from improper access
● After disconnection, the HT 8 must be locked away.
● Emergency Stop buttons that are inactive must not be identified as such or must be
inaccessible. This is to prevent the emergency stop button from being used inadvertently.
Note
An example of TCU and MCP xxx PN as well as optionally an HT 8 or HT 2 on a PN box / PN
module can be found in Chapter: "HT 2", Section: "Commissioning" → "Application example of
HT8 and HT 2 in mixed operation".
Connecting
5.1 Overview
Handheld Terminal HT 8
106 Manual, 07/2015, A5E36371621B-AB
To Next Page
Loading...
