Installation
5
5.1 Preparation for mounting
Table 5-1 Dimensions of the mounting opening
Width (mm) Height (mm)
450 290
Thanks to the tension jacks on the OP 012, drill-holes or screw holes are not needed.
This retaining method also enables the IP65 degree of protection (but only in conjunction with
a circumferential seal and when the protective USB cap is fitted).
Note
The OP 012 is supplied with what are known as "small" tension jacks. If you have the "large"
tension jacks (6FC5248-0AF06-0AA0) in stock, then you can also use these.
3UHVVXUHSRLQWV
IRUWHQVLRQMDFNV
6HDOLQJDUHD
7HQVLRQMDFNVZLWKVHWVFUHZV
0RXQWLQJSDQHO
,QWKHVHDOLQJDUHD
5]
s
s
Figure 5-1 Dimension sheet for installing the OP 012 operator panel front
Operator panel front: OP 012
Manual, 09/2016, A5E36371591B 97
To Next Page
Loading...
Need help?
General
