Using the system
10
Building Technologies 009929_a_en_--.doc
Fire Safety & Security Products 11.2006
Entering the Installer program mode
To access the INSTALLER mode, it is a prerequisite that the system is NOT armed
1. Press <PROG>
2. ENTER: Master/ Installer pin code (default: 258369)
3. <ENTER>
Î DISPLAY: Installer: User
If there is a single long beep at this point and the program LED does not turn on, this means that
you can not access the PROGRAM MODE with your code.
3.1.2 Exiting the program mode
To EXIT any program mode, press <PROG> for 2 seconds.
3.2 Silencing an alarm (signal horn)
1. Enter your PIN code.
2. Press <ENTER>
Î The <OK> indicator goes out, the system is now disarmed.
This stops the alarm at any time and also turns off any audible sirens. The outgo-
ing signals are stopped. This is the same procedure as disarming the system
3.3 How to arm the system before exiting
Preparing the system for arming
Make sure that all zone indicators are off. All doors, exits and windows are closed
and motion in the protected area is restricted or bypassed. The system is ready to
be armed. The green indicator <OK> lights up. If one or more zone indicators are
illuminated, the open zones are indicated.
Close open zones or bypass them. Bypass any zone you cannot close. The <BYPASS> indicator
flashes indicating bypassed zone(s).
Warning Bypassed zones are not protected!
Arming the system
Before leaving the premises you must arm the system. Arming the alarm system
turns on all detectors in the zone/s that are armed.
To Next Page
