General
4
Building Technologies 009929_a_en_--.doc
Fire Safety & Security Products 11.2006
1 General
This document contains significant information on the commissioning of the control
unit. The detailled product documentation is contained in the following manuals:
z 009992 Safety Instructions
z 009930 Installer Manual
z 009905 Technical Reference Manual
z 009929 User Manual
Warning
Read the ‘Safety Instructions’ first before starting to work with the control
panel.
The manuals can be downloaded at:
www.siemens.com/homesecurity
This manual describes the functions corresponding to a general programmed setting of the control
panel. Nevertheless, the functions could be configured by the installer in a different way and there-
fore not be available.
1.1 Country specific standards
The products are developed and produced in compliance with the relevant interna-
tional and European safety standards. Should any additional country-specific, local
safety standards or regulations apply in the place of operation, concerning project
planning, installation, operation and disposal of the product, then these standards
or regulations must be taken into account in addition to the safety regulations men-
tioned in the product documentation.
1.2 Security Information
In the documentation, important information to be respected at any rate is marked
by the symbols indicated below. The additional signal word provides information on
the type of danger.
WARNING
Keywords
Danger; Warning; Caution designate the degree of endangerment.
Useful notes are indicated by the following symbol:
Important, indicates useful notes.
1.3 Notes on graphics
Instead of pictures, the text uses symbols for the designation of the buttons. The
example below shows the graphic representation in short form.
Used keys: Example
Button Short form Text example
<ARM> Press button <ARM> on the keypad
To Next Page
Loading...
