Siemens IC60 - Stay Mode Arming

Using the system
11
Building Technologies 009929_a_en_--.doc
Fire Safety & Security Products 11.2006
Used keys: Arming with a code
PIN
CODE
<CODE> <ENTER>
1. Enter your PIN <CODE>.
2. Press <ENTER> to arm the system.
Î The <OK> indicator lights up to indicate that the system is armed.
There is an exit delay prior to the system being armed. During this delay time, a slow beep sounds
to indicate that the system is not armed yet and to remind you to vacate the protected area.
The indicators may go out few seconds after exit delay times out, depending on the
installation setting.
To immediately ARM the system, press <ARM>.
Used keys: Quick Arm
<ARM>
1. Press <ARM> to arm the system.
Î The <OK> indicator lights up and the system is armed.
During the exit delay time, a slow beep sounds to indicate that the system is not armed yet and to
remind you to vacate the protected area
3.4 Arming the system while people stay at home
Used keys:
PIN
CODE
<STAY> PIN <ENTER>
Arming the system in Stay mode
This type of arming is used when people are present within the protected area.
Consequently, interior movements will be ignored by the system.
1. Press <STAY>.
2. Enter your PIN code.
3. Press <ENTER>
Î The <STAY> indicator flashes indicating that the system is now armed in Stay
mode.