Using the system
17
Building Technologies 009929_a_en_--.doc
Fire Safety & Security Products 11.2006
3.14.2 How to add or change the user code
Enter the CLIENT mode:
1. Press: <PROG>
2. Enter: Master/User Pin Code (default 147258)
3. Press <ENTER>
Î DISPLAY: Client: User
Change the code:
1. Press <1>
2. Press <ENTER>
3. Press <X> ('<X> = The user number (2 to100)
4. <ENTER>
5. Add or change the code with the numeric keyboard
6. <ENTER>
Î If there is an existing code already, it will be shown to you.
7. Use the numeric keyboard to enter the new code. The code may be any combi-
nation of 1 to 6 digits. Entering the new code will delete the old code.
8. Press <ENTER> to save your new code.
9. Repeat the procedure for all users.
10. Press <PROG> for two seconds to exit the Local Program mode.
3.14.3 How to delete a user code
Enter the CLIENT mode:
1. Press: <PROG>
2. Enter: Master/User Pin Code (default 147258)
3. Press <ENTER>
Î DISPLAY: Client: User
Delete the code:
1. Press <1>
2. Press <ENTER>
3. Press <X> ('<X> = User number (2 to100)
Î The code will be shown to you.
4. <ENTER>
5. Press <CTRL> & <0> to delete the user code.
6. Press <ENTER> to save the change.
7. Press <PROG> for two seconds to exit program mode.
To Next Page
