Siemens IC60 - System Function Summary; Summary of System Main Functions

Summary of the system main functions
20
Building Technologies 009929_a_en_--.doc
Fire Safety & Security Products 11.2006
5 Summary of the system main functions
The main functions of the system are listed in the table below.
Function Keys Description Notes
Full or Partition Arm <CODE> & ◄┘ Initiates full arm
Full Arm <ARM> Initiates full arm Only if enabled by installer
Disarm during exit <ARM> Disarms the system during the
exit delay
Only when slow beeping is emitted
Disarm <CODE> & ◄┘ Disarms the system Stopping alarms
Arm Partition <A> or <B> Arms partition A or B Press A or B for
2 seconds to arm the partition in account –
only if enabled by installer
Arm Stay <STAY> & <CODE> ◄┘ Initiates partial alarm when the
user is at home
Only if enabled by installer
Arm Stay >STAY> Initiates partial alarm when the
user is at home
Disarm Stay <CODE> & ◄┘ Disarms the system
Disarm Stay <STAY> Disarms the system
Bypass <BYPASS> & Zone# ◄┘ Bypasses the zone # Repeats the procedure to un-bypass
zones
Initiate Panic <♫> & <CTRL> Activates emergency alert Press simultaneously during 2 seconds
Initiate Medical
Alarm
<♫> & <B> Activates emergency alert Press simultaneously during 2 seconds
Initiate Fire Alarm <A> & <B> Activates emergency alert Press simultaneously during 2 seconds
Memory <UP> Arrow Initiates display of events from
memory.
◄┘ Cancels memory readout
Displays events and automatically scrolls
to the next event after 2.5 sec. (Use arrow
key to scroll manually)
Chime Enable/disable <♫> Enable or disable chime function Holds the key for 2 sec to alternate. Only if
enabled by installer
Control <CTRL> & Device# ◄┘ Activates or deactivates outputs
and devices
Press <CTRL> for 2 seconds
Change or Add
Users code
<PROG> & <Master
CODE> ◄┘
Activates program mode to add
or change user codes
Customize keypad <CTRL> & <LEFT> arrow Enters Local Edit Program mode Press <CONTROL> and then <ARM> and
hold both simultaneously for 2 sec
Increase LCD backlight
level
<CTRL>&<STAY< Hold <>CTRL and press <STAY>
repeatedly to increase light
Decrease LCD backlight
level
<CTRL>&>BYPASS> Hold <CTRL> and press <BY-
PASS> repeatedly to decrease
light
Increase Keypad button
backlight level
<CTRL> & <UP>
arrow
Hold <CTRL> and press <UP>
arrow repeatedly to increase light
Decrease Keypad button
backlight level
<CTRL> & <DOWN>
arrow
Hold <CTRL> and press
<DOWN> arrow repeatedly to
decrease light
Increase buzzer tone <CTRL> & <A> Hold <CTRL> and press <A>
repeatedly to increase buzzer
tone
Decrease buzzer tone <CTRL> & <B> Hold <CTRL> and press <B>
repeatedly to increase buzzer
tone
Tab. 6 Summary of functions
When an operation has started incorrectly, press <ENTER> ◄┘ to exit and return to the previous
mode.
Pressing the <PROG> key for 2 sec returns back to the basic position.