Siemens LMV5 Series - Page 172

172/278
Siemens Building Technologies Basic Documentation LMV51... CC1P7550en
HVAC Products 10 Description of the connection terminals 01.10.2003
10 Description of the connection terminals
Terminal designa- tion
Connection symbol
Input Output
Description Electrical rating
PIN1 x Fan motor contactor AC 230 V +10 % / -15 %, 50...60 Hz,
1 A, cos
ϕ 0.4
X3-01
PIN2
x Alarm AC 230 V +10 % / -15 %, 50...60 Hz,
1 A, cos
ϕ 0.4
PIN1 x Air pressure switch (LP) AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 1.5 mA
X3-02
PIN2
x Power signal for air pressure switch
(LP)
AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 500 mA
PIN1 x End switch burner flange AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 5 A
X3-03
PIN2
x Power signal for end switch burner
flange
AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 5 A
PIN1 x Safety loop AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 5 A
PIN2 x Power signal for safety loop AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 5 A
PIN3 x Protective earth (PE)
PIN4 x Neutral conductor (N)
X3-04
PIN5
x Live conductor (L) AC 230 V +10 % / -15 %, 50...60 Hz,
fuse 6.3 AT
(DIN EN 60 127 2 / 5)
Fuel selection “internal” if pin 1-2 is not
used
PIN1 x Fuel selection gas AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 1.5 mA
PIN2 x Fuel selection oil AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 1.5 mA
PIN3 x Fan contactor contact (FCC) or FGR-
PS
AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 1.5 mA
X4-01
PIN4
x Reset / manual lockout AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 1.5 mA
PIN1 x Protective earth (PE)
PIN2 x Neutral conductor (N)
X4-02
PIN3
x Ignition AC 230 V +10 % / -15 %, 50...60 Hz,
2 A, cos
ϕ 0.2
PIN1 x Protective earth (PE)
PIN2 x Neutral conductor (N)
X4-03
PIN3
x Start signal or PS relief (APS test valve) AC 230 V +10 % / -15 %, 50...60 Hz,
0.5 A, cos
ϕ 0.4
PIN1 x Protective earth (PE)
PIN2 x Pressure switch min-oil (DWmin-oil) AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 1.5 mA
X5-01
PIN3
x Power signal for pressure switch-min-oil
(DWmin-oil)
AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 500 mA
PIN1 x Protective earth (PE)
PIN2 x Pressure switch-max-oil (DWmax-oil) AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 1.5 mA
X5-02
PIN3
x Power signal for pressure switch-max-
oil (DWmax-oil)
AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 500 mA
PIN1 x Controller (ON / OFF) AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 1.5 mA
PIN2 x Controller closes / stage 3 AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 1.5 mA
PIN3 x Controller opens / stage 3 AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 1.5 mA
X5-03
PIN4
x Power signal for control of controller AC 230 V +10 % / -15 %, 50...60 Hz,
Imax 500 mA