Issue 03/01 3 Commissioning
MICROMASTER 411 & COMBIMASTER 411 Operating Instructions
6SE6400-5CA00-0BP0
59
Stopping the Motor
When the inverter is being operated using the Run/Stop switch (connected to
DIN1) setting the switch to OFF will override the potentiometer setting and bring
the motor to a controlled stop.
3.4.4 If the Motor does not start up
Refer to Chapter 6.
3.4.5 If a fault occurs
1. Switch the Inverter off.
2. Disconnect and reconnect the power supply.
3. Switch on again.
4. Faults are acknowledged by using digital input DIN 3 (default setting).
Switch off if the fault condition persists.
To Next Page
Loading...
