BW500 and BW500/L
Operating Instructions, 12/2016, A5E33482052-AD
13
The Milltronics BW500 and BW500/L are to be used only in the manner outlined in this
instruction manual.
These products are intended for use in industrial areas. Operation of this equipment in a
residential area may cause interference to several frequency based communications.
This instruction manual covers the operation, installation, and maintenance of Milltronics BW500
and BW500/L.
Please refer to this manual for proper installation and operation of your BW500 or BW500/L belt
scale integrator. As BW500 and BW500/L must be connected to a belt scale, and optionally a
speed sensor, refer to their manuals as well.
The manual is designed to help you get the most out of your BW500 and BW500/L, and it
provides information on the following:
How to install the unit
Outline diagrams
How to program the unit
Wiring diagrams
How to operate the keypad and read the display
Parameter values
How to do an initial Start Up
Parameter uses
How to optimize and maintain accurate operation of
the unit
MODBUS register mapping
Modem configuration
We always welcome suggestions and comments about manual content, design, and
accessibility. Please direct your comments to
techpubs.smpi@siemens.com
.
For the complete library of Siemens Milltronics manuals, go to Siemens Milltronics manuals
(www.siemens.com/weighing
).
To Next Page
