Mechanical systems 10 - 27
Siemens-Elema AB SPR8-215.898.01 Page 27 of 28 MOBILETT Plus / - E/ - M
Solna, Sweden Rev. 05 01.02 SPS-UD
• Install the new friction linings according to (Fig. 31 or Fig. 32). There are two different
vertical friction linings. Both are equally suitable for the unit.
• Reinstall the upper counter bearing.
• Tighten the screws.
• Check that there is no braking action on the counter bearings.
• Tighten the adjustment screw. Make sure that the spring mechanism is under tension
before releasing the ceiling support.
• Attach the rear, left right and front covers.
• Check parallelism, refer to section "Parallelism".
• Adjust counterbalance, refer to section "Counterbalance".
• Adjust friction linings, refer to section "Adjusting the friction linings".
Fig. 31 Fig. 32
To Next Page
Loading...
