Siemens optiPoint 410 S Series - Using Repdial Keys

Step by Step
Operating the Telephone with the Display
34
: The other party’s number is displayed. Confirm "Store"
to store the number.
or
o Enter another number of your choice and confirm.
"Entry stored" confirms that the number has been
saved.
Calling a stored number
The idle display appears.
Press the "Notebook" function key.
The stored number is displayed.
: Start the dialing process.
Using Repdial Keys
The Repertory Dialing function is similar to selected
dialing. However, it can also incorporate dialing control
functions at any point within the repertory dialing se-
quence.
Procedure for programming Repdial keys, see
 page 56.
Store? >
Notebook
Dial? >
Control Function Action During Dialing
OK <OK> Any characters following this
control function are sent imme-
diately after the call has been
answered, and are sent as DT-
MF.
Pause <PA> Waits 3 seconds before sending
any characters following this
control function.
Consultation <CS> Establish a consultation call at
this point.
Clear <CL> Clear the current call at this
point.