Operating the Telephone with the optiPoint display module
71
Step by Step
Placing a Call on Hold
You can use this function to place an active call on hold.
The other party is informed that they are being placed
on hold.
Prerequisite: You are in the middle of a call.
Press the Hold icon to place the call on hold. The Caller
Box now appears further from the Line.
Press the Reconnect icon to reconnect the call. The
Caller Box now appears closer to the Line.
Ending a Call
During a call you can use the following options to end
the call immediately:
Press the "Clear" icon.
or
t Replace the handset.
Call Control
Mon 07/03/05 11:34AM
00:24
On Hold
Bill Smith
987654321
Consult/Transfer
You can place two calls on hold at the same time.
To Next Page
Loading...
