Siemens optiPoint 410 S Series - Swap Display; Applications Display

Operating the Telephone with the optiPoint display module
67
Step by Step
For further information, please refer to the section:
•
Call Log 
page 86
•
Redial Last No. 
page 85
•
Do not disturb 
page 90
• Ringer on

page 70
• Setup

page 96
Swap Display
You should configure a key to enable you to quickly
swap from the telephone display to the Display Module
Call Control and vice versa ( page 54).
Press this key to swap displays quickly.
Applications Display
Press the Cancel icon in Call Control (

page 66
)
if you
want to cancel Call Control and use other applications.
Press the Home icon in Call Control (

page 66
)
if you
want to continue running Call Control in the back-
ground, but want to use other applications as well.
To return to Call Control, select the appropriate icon and
then press the Select display key.
Swp Display
Applications
Call
Control
Contacts Address
Book
BrowserCall Log Programs
Display Voice
Select