Standards & guidelines
9
Siemens Building Technologies
Fire Safety & Security Products 07.2008
3 Standards & guidelines
This product complies with the requirements of the European Directives.
The EU declaration of conformity is available from:
Siemens Building Technologies
Fire & Security Products GmbH & Co. oHG
76181 Karlsruhe, Germany
European Directive 1999/5/EC on Radio Equipment and Telecommunications
Terminal Equipment (R&TTE):
Compliance with the European Directive 1999/5/EC has been proven by testing
according to the following standards:
R&TTE Directive 1999/5/EC
EN 300 330-2 V1.3.1:2006-04
EN 301 489-3 V1-4-1:2002-08
European Directive 2004/108/EC on Electromagnetic Compatibility (EMC):
Compliance with the European Directive 2004/108/EC has been proven by testing
according to the following standards:
EMC Directive 2004/108/EC EN 50130-4:1995 + A1:1998 + A2:2003
European Directive 2006/95/EC on Low-Voltage Directive (Safety):
Compliance with the European Directive 2006/95/EC has been proven by testing
according to the following standard:
LVD Directive 2006/95/EC EN 60950-1:2006
Power supply
Any power supply connected to the PP500 must conform to CE regulations regard-
ing safety and EMC. This includes conformity to SELV (Safety Extra Low Voltage)
according to EN 60950-1. The supply line fuse shall, independent of host system,
not in any case exceed 10A.
Cable recommendations
The cables used for this product shall be screened and not exceed 30 m. E g the
Belden 9534/9538, Li-YCY.
The screen shall be connected to any screen connector (if this exist) in a door con-
troller - otherwise to the back plate of the PP500.
Note! - Due to the risc of potential differences in the protection earth system of
buildings, only one (1) connection to earth shall be made in a system.
To Next Page
Loading...
