Siemens PUMA VT1100/M - Tool Function (T Function) and Tool Change

PROGRAMMING | 99
2. Tool Function (T Function)
2.1 Tool change with T command
The T function is used to select the specified tool and to set the coordinate system using the
tool offset.
(1) Syntax
Tool selection:
T<number>
T=<number>
T<n>=<number>
Tool deselection:
T0
T0=<number>
T: Command for tool selection including tool change and activation of the tool
Offset
<n>: Spindle number as address extension
<number>: Number of the tool Range of values: 0 - 32000
T0: Command for deselection of the active tool
Example
N10 T1 D1 ; Loading of tool T1 and activation of the tool offset D1.
...
N70 T0 ; Deselect tool T1.