Siemens PUMA VT1100/M - Spindle Axis Mode Command in Auto Mode

OPERATION | 37
5.3 Spindle axis mode command in Auto mode.
(1) Axis mode command format
Example)
M1=70; For C axis for main spindle.
(2) C-axis high clamp/unclamp command only possible in axis mode.
To release axis mode, it need to spindle rotation command(M3/M4) or stop(M5)
command.
M<n>=70
- n : 1 (Main Spindle )
2 (Milling Spindle)