Siemens PUMA VT1100/M - Jog Traverse

OPERATION | 27
4.1 Jog Traverse
Each axis can be traversed using jog traverse switch in operation panel.
(1) Operation method for jog traverse
1
[Jog mode selection]
Press the switch shown in left side, then the machine
becomes jog mode.
1) Linear axis(X,Z) traverse
1-1
[Select X, Z axis button, then press the + or –direction
button, the axis will traverse]
The axis will traverse while the relevant switch of direction
and axis, that want to be traversed, is pressed. The axis
traverse will stop when the switch is released.
▶ + direction
▶ - direction
2) C-axis traverse
2
[Main Spindle Selection]
Press the main spindle switch shown in left side,
2-1
[Press C axis button to change C-axis mode, then
press the + or – direction button]
The axis will traverse while the relevant switch of
direction and axis, that want to be traversed, is
pressed. The axis traverse will stop when the switch is
released.
▶ C-axis +direction
▶ C-axis -direction