Siemens PUMA VT1100/M - Automatic Type Quick Tool Presetter Operation

OPERATION | 67
If turret is inside of teaching position and quick tool presetter operation is performed, then
alarm 700197[Q-setter operation inhibited by turret interference ] will occur, please move the
axis in safe position (outside of teaching position) for operating the Q-setter.
10.1 Automatic type quick tool presetter operation
(1) Manual operation
1
[Manual mode selection]
Change the machine mode into manual mode by
pressing the switch among the switches shown in left
side.
- Jog mode
- handle mode
2
[Check whether the machine has interference or not]
Check whether collision is occurred or not when quick
tool presetter is downed.
3
[Arm down]
Press the switch in operation panel, shown in left side,
then quick tool presetter will be downed and can input
the offset of tool.
4
[Arm up]
Press the switch in operation panel, shown in left side,
then quick tool presetter will be upped and be fixed to
cover of machine.