16 | Part 1
2.4 Optional function switch
For the convenience of operator regarding the machine operation, there are various optional
function switches.
(1) Auto-door operation switch
This switch is used to open/close the door in front of turning center automatically.
Note) This switch can not be activated during the spindle rotation.
When pressing this switch, auto door will be opened and close.
The last selected state is maintained when turning ON the power first.
(2) Automatic measure device (Q-setter) operation switch
This switch is used to up and down the arm of Q-setter.
This switch is to swing up and down the arm of Q-setter.
Above switches are available to operate only if the spindle stops and the parts catcher
doesn't move forward.
To Next Page
Loading...
