PROGRAMMING | 105
(2) Detector procedure
TLM Monitoring Process
▶ Tool Enable set : Set the measuring channel, data number, sister tool check
▶ Dimension Recording: Measure the distance detection
▶ Tool Setting: Set the Tool(Distance, Direction, Feed mode, etc.) to be measured.
▶ Current Recording: Measuring current detection
▶ Tool setting: Set the axis current of selected tool
▶ Monitoring: Execute tool load monitoring
▶ Tool load check: If TLM detects a certain value of off-range, it will generate Cycle alarm.
4.2 Basics operation
To Next Page
Loading...
