OPERATION | 29
4.2 Rapid traverse during jog traversing
Using the jog axis traverse switch and rapid traverse switch in operation panel, each axis
can be traversed in rapid.
(1) Operation method for jog rapid traverse
[Jog mode selection]
Press the switch shown in left side, then the machine
becomes jog mode.
[Axis traverse by pressing direction button with rapid
traverse button at the same time]
Decide the axis and direction that want to be traversed.
The axis will traverse in rapid while the direction button
and rapid traverse button are pressed. The axis will
keep traversing at the speed set by the feed override
when rapid traverse switch is released.
(2) Jog rapid traverse speed
Rapid traverse speed can be adjusted with feed override
switch as shown in the left figure. Regarding to the exact
speed, refer to the specification of machine.
(3) Jog rapid traverse limit
In case that Q-setter is down, rapid traverse using jog switch operation is restricted.
To Next Page
Loading...
