48 | Part 2
7.2 Restrictions in machine operation according to the status of chucking
There are some restrictions in machine operation in case of the unclamp status of chuck as
follows.
- Rotation command of spindle cannot be executed.
(However, in case of commanding M-code M31 to release restrictions with regard to
chucking, rotation command of spindle can be executed. Regarding the more details, refer
to the corresponding section of spindle operation.)
- Automatic operation of machine cannot be started.
(However, in case of commanding M-code M31 to release restrictions with regard to
chucking, automatic operation of machine can be started. Regarding the more details,
refer to the corresponding section of automatic operation of machine.)
- M00, M01 cannot be finished.
(In case of unclamping chuck in M00, M01 during automatic operation, be sure to finish
M00, M01 after clamping.)
To Next Page
Loading...
