Siemens PUMA VT1100/M - Page 6

5. C-AXIS Mode .................................................................................. 35
5.1 C-axis clamp/unclamp operation .......................................................... 36
5.2 Axis traverse and restrictions in C-axis clamp status ........................... 36
5.3 Spindle axis mode command in Auto mode. ........................................ 37
6. SPINDLE ......................................................................................... 38
6.1 Spindle operation ................................................................................. 38
6.2 Spindle selection .................................................................................. 39
6.3 Spindle rotation and operation in manual mode ................................... 40
6.4 Spindle Rotation Command in auto mode ........................................... 41
6.5 Spindle Rotation Condition ................................................................... 43
6.6 Spindle override operation ................................................................... 44
6.7 Spindle Gear Switching ........................................................................ 45
7. CHUCKING OPERATION .............................................................. 46
7.1 Chuck operation ................................................................................... 47
7.2 Restrictions in machine operation according to the status of chucking 48
7.3 Chuck clamp/unclamp check ............................................................... 49
7.4 Chuck clamp/unclamp operation .......................................................... 52
7.5 Dual chucking (option) ......................................................................... 54
7.6 Chucking operation on spindle rotating ................................................ 56
8. TOOL POST ................................................................................... 57
8.1 The movement of tool post ................................................................... 57
8.2 The operation of tool post .................................................................... 58
9. COOLANT OPERATION ................................................................ 61
9.1 Connecting coolant motor and peripheral device ................................. 61
9.2 Standard coolant operation .................................................................. 61
9.3 Optional Coolant .................................................................................. 63
9.4 Mutual operation between standard and optional coolant .................... 63
9.5 Cool jet coolant operation .................................................................... 64
9.6 Coolant Flushing .................................................................................. 65
10. QUICK TOOL PRESETTER (OPTION) .......................................... 66
10.1 Automatic type quick tool presetter operation ...................................... 67
10.2 Manual type quick tool presetter operation .......................................... 69
10.3 Measuring a tool with a tool probe. ...................................................... 70