Siemens SCALANCE M-800 Series User Manual

Connecting SCALANCE M-800 to WAN
1.3 Connecting M826 with SHDSL
SCALANCE M-800 Getting Started
Getting Started, 06/2015, C79000-G8976-C337-04
51
Required devices/components
Use the following components for setup:
● Connection to SHDSL
– 2 x M826 (additional option: a suitably installed standard rail with fittings)
– 2 x 24 V power supply with cable connector and terminal block plug
● 2 x PC each connected to a SCALANCE M826.
● PST is installed on the PC.
Settings used
For the configuration example, the devices are given the following IP address settings:
IP address
Master sta-
tion
M826 192.168.100.1
255.255.255.0
Admin PC 192.168.100.20
255.255.255.0
Station M826 192.168.100.10
255.255.255.0
Admin PC 192.168.100.40
255.255.255.0
Steps in configuration
The following steps are necessary to configure the 4-wire operation
1. Setting up SCALANCE M826 and network (Page 52)
2. Configuring the SCALANCE M826 with the PST (Page 52)
3. Launching Web Based Management (Page 54)
4. Logging in to Web Based Management (Page 56)
5. Configuring SCALANCE M826
The steps are the same for both devices, the only difference being the settings.
– Specifying device information (Page 57)
– Setting the time (Page 58)
– Configuring SHDSL (Page 60)

Siemens SCALANCE M-800 Series Specifications

General

Brand	Siemens
Model	SCALANCE M-800 Series
Category	Network Router
Language	English