Siemens SCALANCE XF200 - Safety notices; General Safety Notices

SCALANCE X-200
Operating Instructions, 03/2015, C79000-G8976-C284-06
27
Safety notices
3
3.1
Safety notices in general
Note the following safety notices. These relate to the entire working life of the device.
WARNING
Do not use any parts that show evidence of damage
If you use damaged parts, there is no guarantee that the device will function according to
the specification.
If you use damaged parts, this can lead to the following problems:
• Injury to persons
• Loss of the approvals
• Violation of the EMC regulations
• Damage to the device and other components
Use only undamaged parts.
Installation guidelines
The product meets the requirements if you adhere to the installation and safety notices
contained in this documentation and in the following documentation when installing and
operating the product.
Current documentation on the Internet
The current descriptions of the currently available products can be found on the Product
Support pages under the entry IDs below:
● Configuration manual SIMATIC NET PH SCALANCE X-200
63203259 (http://support.automation.siemens.com/WW/view/en/63203259
)
● System manual SIMATIC NET Industrial Ethernet Network Manual
27069465 (http://support.automation.siemens.com/WW/view/en/27069465
)
● Configuration manual EMC Installation Guidelines
60612658 (http://support.automation.siemens.com/WW/view/en/60612658
)
Electrostatic discharge
To protect the product process from electrostatic discharge, personnel must first discharge
any electrostatic charge from their body before touching the product.