Siemens SCALANCE XF200 - Installation on a DIN Rail

Installation
4.3 Installation on a DIN rail
SCALANCE X-200
Operating Instructions, 03/2015, C79000-G8976-C284-06
37
4.3
Installation on a DIN rail
Installation
Figure 4-1 Installation on a 35 mm DIN rail
To install an X-200 on a 35 mm DIN rail complying with DIN EN 60715, follow the steps
below:
1. Place the upper catch of the device over the top of the DIN rail and then push in the lower
part of the device against the rail until it clips into place.
2. Fit the connectors for the power supply.
3. Fit the connectors for the signaling contact
4. Insert the terminal blocks or M12 cable connectors into the sockets on the device.
Removal
Figure 4-2 Removing from a 35 mm DIN rail
To remove an X-200 from a DIN rail, follow the steps below:
1. First disconnect all connected cables.
2. Use a screwdriver to release the lower DIN rail catch of the device and pull the lower part
of the device away from the rail.