Siemens SENTRON 7KM PAC2200 - Parameterization Via the Device Menu

Commissioning
6.3 Parameterizing the device
PAC2200
68 Equipment Manual, 12/2019, L1V30415167B-03
"Access protection IP filter" parameter
The IP filter is a configurable access protection. If activated, Modbus TCP write commands
are only accepted if the remote station is located in the same subnet.
Note
It is recommended to activate the hardware write protection on the device.
6.3.2 Parameterization via the device menu
The PAC2200 device can be parameterized via the "Settings" menu option. See chapter
Menu-based navigation (Page 55).
"Language" parameter
The language of menu-based navigation and of the measured value displays can be set in
the "Language" menu item.
Selection
Range
Factory setting
Language
English, German
English
Phase designation
 L1, L2, L3
 a, b, c
L1, L2, L3
"Basic settings" parameter
Not available for 65 A devices.
"Voltage Input" parameter
(Not available for MID devices)
Selection
Range
Factory setting
CONNECTION TYPE
 3P4W: 3 phases,
4 conductors
 1P2W: 1 phase,
2 conductors
3P4W
The "Connection type" parameter limits the total number of measured variables. The input
circuit of the device must correspond to the parameterized connection type.
Inform the device of the connection type used by entering the connection type code in the
device settings.