Commissioning
6.3 Parameterizing with powerconfig
7KT16 energy meter
Equipment Manual, 09/2020, 2514284147-04
81
5. Select PAC1600 in the Search for device option.
6. Enter the communication parameters:
– COM port
– Address
– Baud rate
– Format
– Protocol
7. Click the Start search button.
All devices found are shown in the "Result" window.
8. Select the required device.
9. Click the Create devices button.
The selected device is added.
10. In the Views menu, select the submenu "Parameters".
The "Parameters" window is displayed.
11. In the "Properties" window, click the Load to PC button.
The configuration is loaded from the device to the PC.
Parameterizing the device
The parameters are entered and changed in offline mode.
To switch between online and offline mode, click Activate online view in the Options menu
or press the F12 key.
Set the required basic parameters.
Make use of the Online Help in powerconfig.
In order to load the parameters to the device, proceed as follows:
1. Integrate the device in powerconfig.
2. In the Views menu, select the submenu Parameters or alternatively press the "Ctrl" and
"Pos1" keys simultaneously.
The "Parameters" window is displayed.
3. In the "Parameters" window, click the Load to PC button.
The set parameters are loaded to the device.
To Next Page
Loading...
